Nortel M3820 Installation And Administration Manual page 99

January 2005
IF you want to
manually enter
static IP
information for
this Digital
Telephone IP
Adapter unit,
(continued)
enable prioritizing
of voice packets in
the IP header
(DiffServ),
Digital Telephone IP Adapter Installation and Administration Guide
Configuring the IP Adapter unit using the telephone menu
THEN do the following:
7 Press 2 and proceed to Enable DiffServ?
[1-Yes 2-No], below, to leave the Digital
Telephone IP Adapter unit's IP gateway as it is.Press
1 to modify the Digital Telephone IP Adapter unit's
IP gateway.
8 Press the Hold key.
Result: The telephone display prompts you for the
Digital Telephone IP Adapter unit's new, permanent
IP gateway. The telephone display also shows the
current setting, similar to the following:
Enter IP Gateway
0.0.0.0
9 Press the digits of the Digital Telephone IP Adapter
unit's permanent IP gateway. Use the * key for the
IP address delimiter. (Refer to the table on page 85.)
10Press the Hold key.
Result: The telephone display asks if you want to
enable DiffServ, similar to the following:
Enable DiffServ?
[1-Yes 2-No]
Note: The Remote Gateway 9100 Series family of
products does not support Classless Inter-Domain
Routing (CIDR).
1 Press 1.
2 Press the Hold key.
3 Proceed to "Enable 802.1Q Mapping? [1-Yes 2-
No]" on page 100.
Note: Refer to the Reach Line Card Installation and
Administration Guide for information on DiffServ
CodePoint and 802.1Q Mapping.
99