Nortel M3820 Installation And Administration Manual page 97

January 2005
12 The telephone display asks if you want to modify the IP parameters, similar
to the following:
Modify IP Parameters?
[1-Yes 2-No]
IF you want to
retain the current
IP parameters
configured for this
Digital Telephone
IP Adapter unit,
modify the IP
parameters
configured for this
Digital Telephone
IP Adapter unit,
allow a DHCP
server to
dynamically
assign an IP
address to this
Digital Telephone
IP Adapter unit
each time
someone logs on
with this unit,
Digital Telephone IP Adapter Installation and Administration Guide
Configuring the IP Adapter unit using the telephone menu
THEN do the following:
1 Press 2.
2 Press the Hold key.
3 Proceed to step 13 on page 101.
1 Press 1.
2 Press the Hold key.
Result: The telephone display asks if you want to
enable Dynamic Host Configuration Protocol
(DHCP), similar to the following:
Enable DHCP?
[1-Yes 2-No]
1 Press 1.
2 Press the Hold key.
3 Proceed to "Enable DiffServ? [1-Yes 2-No]" on
page 99.
Note: Refer to the Reach Line Card Installation and
Administration Guide (NTP 555-8421-210) for more
information on DiffServ CodePoint and 802.1Q
Mapping.
97