Nortel M3820 Installation And Administration Manual page 100

Configuring the IP Adapter unit using the telephone menu
IF you want to
not enable
prioritizing of
voice packets in
the IP header,
enable prioritizing
of voice packets in
the IEEE Media
Access Control
layer (802.1Q),
100
THEN do the following:
1 Press 2.
2 Press the Hold key.
Result: The telephone display asks if you want to
enable 802.1Q Mapping, similar to the following:
Enable 802.1Q Mapping?
[1-Yes 2-No]
1 Press 1.
2 Press the Hold key.
Result: The telephone display prompts you for the
VLAN ID, similar to the following:
VLAN ID [0-4094] 0=NC:
0
3 Enter the Virtual Local Area Network (VLAN) ID
for 802.1Q Mapping.
Valid entries are 0 (0 = Not Configured) through
4094 (0xFFE). The default is 0.
4 Press the Hold key.
Result: The telephone display prompts you for the
802.1Q priority value, similar to the following:
802.1Q Priority [0-7]
5
5 Enter the priority value for 802.1Q Mapping.
Valid entries are 0 through 7. The default is 6.
6 Press the Hold key.
Result: The telephone display prompts you for the
DiffServ CodePoint value, similar to the following:
DiffServ CodePoint Val:
EF
Digital Telephone IP Adapter Installation and Administration Guide
Standard 2.1