Yamaha FJR1300A(D) Service Manual page 650

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
Diagnostic
code No.
03 Intake air pressure
05 Air temperature
06 Coolant temperature
07 Rear wheel vehicle speed
pulses
08 Lean angle sensor
• Upright
• Overturned
09 Fuel system voltage
(battery voltage)
13 Throttle position sensor
signal 2
• Fully closed position
• Fully open position
14 Accelerator position sen-
sor signal 1
• Fully closed position
• Fully open position
Item
Displays the intake air
pressure.
Displays the air tempera-
ture.
When engine is cold: Dis-
plays temperature closer
to air temperature.
When engine is hot: Dis-
plays current coolant tem-
perature.
Rear wheel speed pulse
0–999
Lean angle sensor output
voltage
0.4–1.4
3.7–4.4
Approximately 12.0
9–23
94–108
12–22
97–107
Meter display
9-7
Procedure
Shift the transmission into
gear, extend the side-
stand, and then operate
the throttle while pushing
the " " side of the
start/engine stop switch.
(If the display value
changes, the perfor-
mance is OK.)
Compare the actually
measured air temperature
with the meter display val-
ue.
Compare the actually
measured coolant temper-
ature with the meter dis-
play value.
Check that the number in-
creases when the rear
wheel is rotated. The num-
ber is cumulative and
does not reset each time
the wheel is stopped.
Remove the lean angle
sensor and incline it more
than 65 degrees.
Set the start/engine stop
switch to " ", and then
compare the actually mea-
sured battery voltage with
the meter display value. (If
the actually measured bat-
tery voltage is low, re-
charge the battery.)
Check with throttle valves
fully closed.
Check with throttle valves
fully open.
Check with throttle grip ful-
ly closed position.
Check with throttle grip ful-
ly open position.