Yamaha FJR1300A(D) Service Manual page 519

Fault code No.
Item
Meter display
Procedure
Probable cause of mal-
Item
function and check
1 Locate the malfunction.
2 Clutch lever adjustment.
3 Connection of clutch switch
coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
42
Rear wheel sensor: no normal signals are received from the
A
rear wheel sensor.
B Neutral switch: open or short circuit is detected.
C Clutch switch: open or short circuit is detected.
Clutch switch
• "ON" (when the clutch lever is squeezed with the transmission in
gear and when the sidestand is retracted)
• "OFF" (when the clutch lever is squeezed with the transmission
in gear and when the sidestand is extended)
Operate the transmission, clutch lever, and sidestand.
Maintenance job
Execute the diagnostic
mode. (Code No. 07)
Rotate the rear wheel by
hand and check that the indi-
cated value increases.
Execute the diagnostic
mode. (Code No. 21)
When the transmission is in
neutral: "ON"
When the transmission is in
gear with the clutch lever re-
leased: "OFF"
When the transmission is in
gear with the clutch lever
squeezed and the sidestand
retracted: "ON"
Refer to "ADJUSTING THE
CLUTCH LEVER" on page
3-12.
Improperly connected →
Connect the coupler secure-
ly or replace the wire har-
ness.
8-70
FUEL INJECTION SYSTEM
Confirmation of service
completion
Value does not increase →
Go to item 2 in section A for
the rear wheel sensor.
Incorrect indication → Go to
item 2 in section B for the
neutral switch.
Incorrect indication → Go to
item 2.
Execute the diagnostic
mode. (Code No. 21)
When the clutch lever is re-
leased: "OFF"
When the clutch lever is
squeezed: "ON"
Correct indication→ Go to
item 9.
Incorrect indication → Go to
item 3.
Execute the diagnostic
mode. (Code No. 21)
When the clutch lever is re-
leased: "OFF"
When the clutch lever is
squeezed: "ON"
Correct indication→ Go to
item 9.
Incorrect indication → Go to
item 4.