Yamaha FJR1300A(D) Service Manual page 123

1. Rear wheel sensor lead
2. Brake hose (rear brake master cylinder to brake
pipe/middle joint assembly)
3. Rear brake fluid reservoir hose
4. Rear brake fluid reservoir
5. Brake pipe (hydraulic unit to metering valve)
6. Hydraulic unit assembly
7. Brake pipe (hydraulic unit to proportioning valve)
8. Brake pipe/upper joint assembly
9. Brake pipe/middle joint assembly
10. Brake pipe/lower joint assembly
11. Rear brake light switch lead
12. Brake pipe (metering valve to right front brake
caliper)
13. Brake pipe (front brake master cylinder to brake
pipe/lower joint assembly)
14. Brake pipe (brake pipe/upper joint assembly to
front brake calipers)
15. Rear brake light switch
16. Brake hose (brake pipe to rear brake caliper)
A. Route the rear wheel sensor lead to the inside of
the swingarm, making sure that the lead does not
protrude above the swingarm.
– –
B. 45 55 mm (1.77 2.17 in)
– –
C. 20 30 mm (0.79 1.18 in)
D. Fasten the rear brake light switch lead and rear
wheel sensor lead with the holder.
E. Fasten the brake pipe (brake pipe/upper joint
assembly to front brake calipers), rear wheel
sensor lead, and rear brake light switch lead with a
plastic locking tie. Face the end of the plastic
locking tie inward.
F. Fasten the rear wheel sensor lead to the brake
hose (brake pipe to rear brake caliper) with the two
holders, making sure that the fastener of each
holder faces inward.
2-52
CABLE ROUTING