Yamaha FJR1300A(D) Service Manual page 129

1. Wire harness
2. License plate light connectors
3. Tail/brake light assembly coupler
4. Tail/brake light
5. Rear turn signal light
6. Tail/brake light assembly lead
7. License plate light lead
8. Seat lock cable
9. Brake switch relay
10. Brake light relay
11. ABS ECU coupler
12. Rear wheel sensor lead
13. Rear brake light switch lead
14. Hydraulic unit assembly
15. Lean angle sensor
16. Yamaha diagnostic tool coupler
A. Route the wire harness so that the joint couplers
are positioned on top of the harness.
B. Route the wire harness to the inside of the seat
lock cable.
C. Pass the license plate light lead through the hole in
the rear fender.
D. Securely connect the ABS ECU coupler.
E. Secure the plastic band by inserting the projection
on the band into the hole in the rear fender, and
then fasten the wire harness at the positioning tape
with the band.
F. Insert the projection on the wire harness holder
into the hole in the rear fender.
G. Route the rear right turn signal light lead under the
right tail/brake light bulb socket.
H. Route the rear right turn signal light lead and right
tail/brake light lead over the left tail/brake light bulb
socket.
I. Route the leads between the left tail/brake light
bulb socket and the rear left turn signal light bulb
socket.
J. Route the tail/brake light assembly lead between
the left tail/brake light bulb socket and the
mounting boss on the tail/brake light assembly.
K. Route the tail/brake light assembly lead between
the tail/brake light assembly and its bracket.
2-58
CABLE ROUTING