Yamaha FJR1300A(D) Service Manual page 529

Fault code No.
Item
Meter display
Procedure
Probable cause of mal-
Item
function and check
1 Locate the malfunction.
2 Connection of front wheel
sensor coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
3 Connection of ABS ECU
coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
69
Front wheel sensor: no normal signals are received from the
front wheel sensor.
Front wheel speed pulse
0–999
Check that the number increases when the front wheel is rotated.
The number is cumulative and does not reset each time the wheel
is stopped.
Maintenance job
If the ABS warning light is
on, refer to "BASIC IN-
STRUCTIONS FOR TROU-
BLESHOOTING" on page
8-132.
If the ABS warning light is
off, perform the following pro-
cedure.
Rotate the front wheel by
hand and check that the indi-
cated value increases.
Value increases → Go to
item 9 and delete the fault
code.
Value does not increase →
Go to item 2.
Improperly connected →
Connect the coupler secure-
ly or replace the wire har-
ness.
Improperly connected →
Connect the coupler secure-
ly or replace the wire har-
ness.
8-80
FUEL INJECTION SYSTEM
Confirmation of service
completion
—
Execute the diagnostic
mode. (Code No. 16)
Rotate the front wheel by
hand and check that the indi-
cated value increases.
Value increases → Go to
item 9 and delete the fault
code.
Value does not increase →
Go to item 3.
Execute the diagnostic
mode. (Code No. 16)
Rotate the front wheel by
hand and check that the indi-
cated value increases.
Value increases → Go to
item 9 and delete the fault
code.
Value does not increase →
Go to item 4.