Alarm connection
When a signal output from the other device is supplied to the Alarm input 1 to 9 terminals (pin nos. 1 - 9), recording or an alarm
action will be performed in accordance with the settings.
When an alarm device such as a buzzer, a lamp, etc., is installed outside, connect them to the Alarm output terminal (pin no. 21).
* Attached when necessary
Time and polarities of the ALARM/CONTROL connector
Terminal
Alarm input
Network error output
Alarm reset input
Face matching output
HDD error output
Camera error output
Recorder error output
Recording error output
Time adjustment signal input
Alarm output
* The error output duration is configured on the "Advanced setup" menu - the "Maintenance" page of the setup menu.
(☞ Page 71)
Note:
• During "L active (Low active)", the logic will be implemented when the voltage level of signal is low.
• During "H active (High active)", the logic will be implemented when the voltage level of signal is high.
28
Sensor
(Signal ground)
Alarming device
Relays, etc.*
(Alarm output)
Activation time
100 ms or more
At an error occurrence until the period selected for "Error
output duration" has passed*
100 ms or more
The set time on the setup menu
At an error occurrence until the period selected for "Error
output duration" has passed*
At an error occurrence until the period selected for "Error
output duration" has passed* or the camera reset
At an error occurrence until the period selected for "Error
output duration" has passed*
At an error occurrence until the period selected for "Error
output duration" has passed*
Input: 100 ms or more
The set time on the setup menu
13
9
14
1
21
ALARM/CONTROL
Door security
switch
Remarks
N.O.: L active
N.C.: H active
L active
L active
L active
L active
L active
L active
L active
L active
L active