Configure The Settings Relating To Maintenance [Maintenance]; Check The System Information Such As The Version [System Information]; Confirm The Hard Disk Drive Information [Hdd Information] - Panasonic WJ-NV200K Installation Manual

Configure the settings relating to maintenance [Maintenance]

The version of the recorder and disk information is displayed, and the settings relating to hard disk drives can be configured on
the setup menu - the "Advanced setup" menu - the "Maintenance" page. It is also possible to initialize the setup data of the
setup pages, check the system logs and register the license on this page.
The "Maintenance" page has [System information], [HDD information] and [System management] tabs.

Check the system information such as the version [System information]

The version (of the software and hardware), serial number, network information (MAC address, IP address, line speed), tempera-
ture inside the recorder and highest temperature inside the recorder, etc. are displayed on this tab.

Confirm the hard disk drive information [HDD information]

The capacity and operation time of the hard disk drives on the recorder and the time range of the images recorded on the hard
disk drives are displayed on this tab.
Note:
• HDD information will not be updated while the
"Maintenance" page is being displayed.
• The hard disk drives installed in the HDD1 slot and the
HDD2 slot are displayed as "HDD1" and "HDD2" respec-
tively.
[Capacity]
Displays the capacities of the hard disk drives.
[Operation]
Displays the operating time of the hard disk drives.
70
Note:
• System information will not be updated while the
"Maintenance" page is being displayed.
• Besides the setting value for "Line speed", the actual line
speed will be displayed in "( )".
• The temperature will be displayed after around an hour
has passed after the power of the recorder is turned on.
"--" is displayed instead of the temperature before an
hour has passed.
[Status]
Displays the statuses of the hard disk drives.
Normal: Hard disk drives that are operating normally
Playback-only: Hard disk drives for playback use only
(Recording is unavailable.)
Removed: Hard disk drives that are excluded from oper-
ation due to fault
Error: Hard disk drives that have become faulty during
the format process
Blank: No connection to hard disk drives
[Recorded time range]
Displays the time range of the images recorded on the hard
disk drives.
[Overwrite cycle]
Calculates and indicates the overwriting cycle of the hard
disk drives, based on the past recording performance (the
date & time of the oldest recorded data, the current date &
time and the capacity of the hard disk drive).