Camera Setup [Camera] - Panasonic WJ-NV200K Installation Manual

Camera setup [Camera]

The "Camera" page has 2 tabs; the [Camera registration] tab and the [Camera setup] tab.
[Camera registration] tab
Perform settings such as the network settings of the camera (IP address and port number), and the display position on the main
monitor.
When performing the initial settings, display camera information detected/set on the "Easy Start".
[Registered information]
Change the "Model", "IP address" and "Compression".
When the [Setup >] button is clicked, the "Registered infor-
mation" window opens to edit the settings. (☞ Page 45)
In the event of communication trouble with the camera, one
of the following error messages is displayed for "Error infor-
mation".
Connection error: The communication with the camera
disconnected.
Authentication error: The user authentication of the cam-
era failed.
Camera error: The response from the camera is incor-
rect.
Note:
• When an error message is displayed, check the camera
connections and settings (☞ operating instructions of
the camera). If the problem cannot be solved, register
the camera again on "Easy Start". (☞ Page 38)
[Change the display position of camera]
The camera numbers can be interchanged. When the
[Setup >] button is clicked, the "Change the display position
of camera" window opens to edit the settings. (☞ Page 46)
44