Panasonic WJ-NV200K Installation Manual page 49

Set up VMD alarm [VMD alarm]
Select the VMD function for each camera and transmit the information to the cameras to change the camera settings.
Clicking the [Setup >] button for "VMD alarm" on the [Camera setup] tab will display the following items.
[VMD alarm]
Select whether or not to use the VMD (VMD: Video Motion
Detection) alarm function when a change (movement) is
detected in the image. Refer to the operating instructions of
the camera in use for how to configure the VMD alarm.
On: Detects alarms.
Off: Does not detect alarms.
Default: On
■ Camera selection
Select the camera to which the VMD alarm setting is to be
sent. Mark the checkbox of the camera to transmit to.
[Transmission] button
Transmit the VMD settings to the camera.
Once transmission is completed and the setting has been
applied to the camera, "OK" will be displayed in the
"Results" field. If the display reads "Authentication error",
etc., the camera connection or the setting may have failed.
[Back] button
Click this button after completing the settings. The screen
returns to the [Camera setup] tab.
49