Configure The Settings Relating To Network [Network]; Configure The Basic Network Settings [Basic] - Panasonic WJ-NV200K Installation Manual

Configure the settings relating to network [Network]

The settings relating to the network of the recorder are configured on the setup menu - the "Advanced setup" menu - the
"Network" page.
The "Network" page has [Basic], [e-Mail], [Panasonic alarm protocol] and [NTP/SNMP] tabs.

Configure the basic network settings [Basic]

The basic settings relating to the network can be configured on this tab.
Note:
• Enter the address octets and port numbers right-aligned.[For example, for port number 80, enter 00080] The leading zeros
are omitted here.
■ Network Setup
Configure the network settings of the recorder.
[IP address]
The IP address of the recorder will be displayed.
To change the IP address, click the [D]/[C] button.
Default: 192.168.000.250
[Subnet mask]
Select the subnet mask in accordance with the recorder's
network environment. Enter in the same way as the IP
address.
Default: 255.255.255.000
[Default gateway]
Select the address for the default gateway in accordance
with the recorder's network environment. Enter in the same
way as the IP address.
Default: 192.168.000.001
[Line speed]
Specify the line speed for data transmission.
Auto: Line speed will be applied automatically.
100M-Full: 100 Mbps full-duplex
100M-Half: 100 Mbps half-duplex
10M-Full: 10 Mbps full-duplex
10M-Half: 10 Mbps half-duplex
Default: Auto
Important:
• When the setup menu is closed after changing the line
speed, the recorder will automatically reboot.
■ DNS Setup
The settings relating to DNS (Domain Name Server) can be
configured on this tab.
[DNS]
Determine whether or not to use the DNS.
Off: Does not use the DNS.
Manual: When using DNS, it is possible to search IP
addresses by host name.
Default: Off
[Primary server address]
[Secondary server address]
When the DNS is used, select the IP addresses for the pri-
mary and secondary DNS server. Enter in the same way as
the IP address.
Default: 0.0.0.0
[Domain name]
Enter the domain name of the recorder. The first character of
the domain name should be an alphabetical character.
Enter 3 to 63 alphanumeric characters including hyphens (-)
and periods (.).
Default: localdomain
61