About The Connector; How To Use The Terminals Of The Alarm/Control Connector - Panasonic WJ-NV200K Installation Manual

About the connector

How to use the terminals of the ALARM/CONTROL connector

This connector is used when connecting an external device such as a sensor that outputs alarm signals or when installing an
external alarm device such as a buzzer or a lamp. The connector to be used should be compatible with the pin array.
Pin array
The pin array is different from other Panasonic recorders. Make sure
that the connection is correct referring to the following.
Pin No.
1 Alarm input 1
2 Alarm input 2
3 Alarm input 3
4 Alarm input 4
5 Alarm input 5
6 Alarm input 6
7 Alarm input 7
8 Alarm input 8
9 Alarm input 9
10 Network error output
11 Alarm reset input
12 N/A
13 Signal ground
14 Signal ground
15 Face matching output
16 HDD error output
17 Camera error output
18 Recorder error output
19 Recording error output
20 Time adjustment signal input
21 Alarm output
22 N/A
23 N/A
24 N/A
25 +5 V output
26
Signal
Event action will be performed according to the
settings.
Signal output upon detection of a broken
Ethernet link
Canceling the alarm display
Signal output at the occurrence of a face match-
ing alarm
Signal output upon detection of an HDD error
Signal output upon detection of a camera error
Signal output upon detection of a recorder error
Signal output upon detection of a recording error
According to the signal input from the other
device, the time of this recorder will be adjusted
to the hour (00 minutes 00 seconds).
Alarm signal will be supplied at an event occur-
rence (Except for a face matching alarm)
+5 V output
13
25
Operation
1
ALARM/CONTROL
14
Remarks
Non-voltage make contact, 5 V
pull-up/−100 mA
Open collector output, 24 V DC
max., –100 mA
Non-voltage make contact, 5 V
pull-up/−100 mA
Open collector output, 24 V DC
max., –100 mA
Non-voltage make contact, 5 V
pull-up/−100 mA
Open collector output, 24 V DC
max., –100 mA
200 mA max.