OfficeServ 7030
TECHNICAL MANUAL
2.3 Replacing the Boards
If the OfficeServ 7030 system fails to operate normally due to an error on the power supply
board, or daughter board, replace the board with a new one.
Removing the Cables
Before replacing a daughter board, remove all cables connected to the board.
To replace a board mounted in the slot of a cabinet, proceed as follows:
1) Turn off the power of the cabinet in which the board is mounted.
2) Remove the cable duct cover and open the upper case. Refer to section '2.1.1 Opening'.
Figure 2.18 Turning Off the Cabinet Power
2.12
Home Page
INSTALLATION
PART 2 MAY 2010