Main Messages And Remedies - Olivetti d-COLOR MF652 Troubleshooting Manual

8.4

Main messages and remedies

8.4 Main messages and remedies
Message
[TX failed due to error. Please
check Job History.]
[Unable to check sender.]
[Not enough memory to contin-
ue scanning. Send as much as
scanned by pressing the [Send]
key or press the [Delete] key.]
[Transmission failed. Please
check line connection.]
[Server connection error.]
[Cannot select address for TX.
Exceeded the maximum
number of addresses allowed
for broadcasting.]
[The document could not be
saved in the User Box due to in-
sufficient HDD capacity. Check
log.]
[The number of registered boxes
has reached the maximum limit.
No additional boxes can be cre-
ated.]
[The number of documents in
the box has reached the maxi-
mum limit. No additional docu-
ments can be stored.]
[The number of programmed
jobs has reached the max. al-
lowance. Wait until a pro-
grammed job is completed.]
d-Color MF 752/652
Cause
Redial was attempted the
number of times specified, how-
ever, transmission failed be-
cause the recipient was busy or
due to other reasons.
The machine failed to verify the
recipient with Check Dest. &
Send set to [ON].
All the available space in the
memory has been used up by
document scanning.
The modular cable may be dis-
connected.
(1) The network cable is not con-
nected correctly.
(2) Under [Administrator Set-
tings], [Network Settings] are not
set correctly.
The number of destinations
specified exceeds the number
possible for a broadcast trans-
mission.
The hard disk is full.
The number of User Box that can
be registered has reached the
maximum number possible.
The number of documents that
can be saved in a User Box has
reached the maximum number
possible.
The number of jobs that can be
programmed has reached the
maximum number possible.
Remedy
Check the recipient's state and
then resend the fax.
Check that the recipient's fax
number is correctly registered.
Press the Start key to send doc-
ument pages that have already
been, then press the Stop key to
abort the job.
Check the modular cable con-
nection and, if unplugged, plug it
in securely.
(1) Make sure that the network
cable is correctly connected.
(2) Under [Administrator Set-
tings], check that [Network Set-
tings] are set correctly.
Reduce the number of broadcast
destinations, or send the trans-
mission in multiple batches.
Delete unnecessary data, then
try saving the data again.
Delete unnecessary User Boxes
then retry registration.
Delete unnecessary documents
then retry registration.
Wait until a job has been com-
pleted, or delete a current job.
8
8-7