Olivetti d-COLOR MF652 Troubleshooting Manual page 80

9
Description of problem
Images are tipped.
An output copy is curled.
The area around an image gets
smudged.
Cannot switch to the 2-Sided >
1-Sided or 2-Sided > 2-Sided
function.
On a device with account track
enabled, copying would not
start even after entering the
password.
The staple position deviates by
90 degrees.
9-4
Check points
Is the original positioned correct-
ly?
Is the original incorrectly posi-
tioned in the ADF?
Is the Slit Scan Glass dirty?
(When the ADF is in use)
Is the lateral guide of the paper
tray correctly aligned with the
paper?
Has curled paper been loaded
into the paper tray?
Curls may appear depending on
the paper type (recycled paper,
for example).
Is the Original Pad dirty?
Is the paper selected of a size
larger than the original size?
(When copying at full size or
100.0% zoom ratio)
Is the size or orientation of the
original different from that of the
paper?
(When copying at full size or
100.0% zoom ratio)
Have you selected the zoom ra-
tio for reduced copying that is
suited for the paper size?
(When the reduced copying
zoom ratio has been selected
manually)
Have settings been selected that
cannot be combined?
Did the message [The counter for
the account has reached its
maximum allowance.] appear?
Has the staple position been cor-
rectly specified?
Cannot copy
Remedy
Correctly position the original
against the Original Scale.
Load the original into the ADF,
and slide the adjustable Lateral
Guide to fit the size of the origi-
nal.
If the original cannot be fed cor-
rectly through the ADF, make
copies by positioning the original
on the Original Glass.
Clean the Slit Scan Glass.
Align the Lateral Guide with the
edges of the paper.
Manually flatten the paper and
re-load it into the paper tray.
Remove the paper from the pa-
per tray, turn it over, and then
load it again.
Replace with new dry paper.
Clean the Original Pad with a
soft cloth dampened with a mild
detergent.
Select a paper size that is the
same size as the original.
Otherwise, tap [Zoom] on the
copy main screen to select [Au-
to], and perform enlarged copy-
ing at a zoom ratio matching the
paper.
Select a paper size as large as
the original.
Otherwise, re-load paper in the
same orientation as the original.
Select the zoom ratio that
matches the paper size.
Otherwise, tap [Zoom] on the
copy main screen to select [Au-
to], and perform reduced copy-
ing at a zoom ratio matching the
paper.
Check the combinations of the
selected settings.
Contact your administrator.
Specify the staple position cor-
rectly. For information on how to
configure the staple settings, re-
fer to [User's Guide: Copy Oper-
ations].
d-Color MF 752/652
9.1