Did Translation Number Conversion - NEC SL1100 Programming Manual

SL1100
Level:
SA
Description
Use Program 22-11 : DID Translation Number Conversion to specify for each Translation Table
Program
entry (800).
• The digits received by the system (eight maximum)
22
• The extension the system dials after translation (36 digits maximum)
• The name that should show on the dialed extension display when it rings (12 characters maximum)
• The Transfer Target - 1 and 2
If the Transfer Targets are busy or receive no answer, those calls are transferred to the final transfer
destination (Program 22-10).
• Operation Mode
Use the following chart when entering and editing text for names. Press the key once for the first
character, twice for the second character, etc. For example, to enter a C, press 2 three times.
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad digit ...
Input Data
2-268
Program 22 : Incoming Call Setup

22-11 : DID Translation Number Conversion

1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | }
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters: 0 ! " # $ % & ' ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters:
*
# # = Accepts an entry (only required if two letters on the same key are needed - ex :
TOM). Pressing # again = Space. (In system programming mode, use the right ar-
row soft key instead to accept and/or add a space.)
Clear/Back Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
Conversion Table Number
Key for Entering Names
When you want to ...
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
*
Á À Â Ã Å Æ Ç É Ê ì ó 0
001 ~ 800
Program 22 : Incoming Call Setup
ISSUE 6.0