NEC SL1100 Programming Manual page 129

ISSUE 6.0
Item Item
No.
09 Private Line
10 DTMF Tones for
Outgoing Calls
11 Account Code
Required
13 Trunk-to-Trunk
Transfer
14 Long Conversa-
tion Cutoff
15 Long Conversa-
tion Alarm Be-
fore Cutoff
16 Forced Release
of Held Call
17 Trunk to Trunk
Warning Tone for
Long Conversa-
tion Alarm
18 Warning Beep
Tone Signaling
19 Privacy Mode
Toggle Option
20 Block Outgoing
Caller ID
21 Caller ID Block
Code
22 Caller ID to Voice
Mail
Programming Manual
Input Data
0 = Disable Private
Line (Normal)
1 = Enable Private Line
(Private Line)
0 = Disable (No) Use this option to enable (1) or disa-
1 = Enable (Yes) ble (0) DTMF tones for outgoing
trunk calls.
0 = Disabled (user can- Per trunk enable or disable the abili-
not enter account co- ty to enter an account code on an
des using this trunk.) inbound or outbound trunk call.
1 = Enabled (user can
enter account codes
using this trunk.)
0 = Disable (No) Use this option to enable (1) or disa-
1 = Enable (Yes) ble (0) loop supervision for the
trunk. This option is required for Call
Forwarding Off-Premise and Tan-
dem Trunking only.
0 = Disable (No) Use this option to enable or disable
1 = Enable (Yes) the Long Conversation Cutoff fea-
ture for each trunk.
0 = Disable (No) Use this option to enable or disable
1 = Enable (Yes) the Long Conversation Alarm for
each trunk.
0 = Disable (No) Use this option to enable/disable
1 = Enable (Yes) forced release for calls on Hold. If
enabled, the system disconnects a
call if it is on Hold longer than a pro-
grammed interval (Program
24-01-05). If disabled, forced dis-
connection does not occur. Program
24-01-01 also affects this option.
0 = Disable (No) Use this option to enable or disable
1 = Enable (Yes) the Warning Tone for Long Conver-
sation feature for DISA callers.
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No) Use this option to enable or disable
1 = Enable (Yes) a trunk ability to be switched from
private to non-private mode by
pressing the line key or Privacy Re-
lease function key.
0 = Prevent (No) Allow (1) or prevent (0) the system
1 = Allow (Yes) from automatically blocking outgoing
Caller ID information when a user
places a call. If allowed (i.e. block,
enabled), the system automatically
inserts the Caller ID block code (de-
fined in 14-01-21) before the user
dialed digits.
Dial (up to eight dig- Enter the code, up to 8 digits, that
its) should be used as the Caller ID
Block Code. This code is automati-
cally inserted before dialed digits if
Program 14-01-20 is set to 1.
0 = Disable (Caller ID Enable or disable the system ability
not sent to VM.) to send the Caller ID digits (Remote
1 = Enable (Caller ID is Log-On Protocol) to voice mail.
sent to VM.)
Description Default
SL1100
Related
Program
0
0
1
Program
1
14
0 20-21-03
20-21-04
0 20-21-01
20-21-02
0 24-01-01
24-01-05
0
0
0
0 14-01-21
20-08-15
67 14-01-20
*
20-08-15
0
2-109