Dtmf And Dial Tone Circuit Setup - NEC SL1100 Programming Manual

ISSUE 6.0
Program 10 : System Configuration Setup
Level:
IN
Description
Use Program 10-09 : DTMF and Dial Tone Circuit Setup to allocate the circuits on the CPU for
either DTMF receiving or dial tone detection. The CPU has 16 circuits initially, and an additional 16
circuits are added when a VMDB is installed. By Adding EXIFE system can have up to 128 (V3.5 or
higher). These are used as follows:
• Extension: DTMF receiver for single line telephone
• Trunk: DTMF receiver for analog trunks, dial tone & busy tone detection for analog trunks
Input Data
Circuit/Resource Number
Item Item
No.
01 DTMF Dial Tone Detection
Conditions
• CPU has 16 Channel DSP resources (receivers) only for basic CPU Unit. VMDB has additional 16
DSP resources which you can add to CPU. Addition to that EXIFE also each has 32 DSP resource
(receivers) only for expand unit.
• In case of 0 (= Common) is selected, and if 14-02-10 (Caller ID receive ability) is set to "Yes", DSP
resources are always allocated to analog trunk only, not for analog extension. If 14-02-10 is set to
"No", the DSP resources can be used for both analog trunk and analog extension commonly.
Feature Cross Reference
• Caller ID
Programming Manual

10-09 : DTMF and Dial Tone Circuit Setup

Input Data
0 = Common Use
1 = Extension Only
2 = Trunk Only
01 ~ 128 (V3.5 Changed)
Default
Resource 01 - 128 = 0
(Common) (V3.5
Changed)
Resource 01 - 16 are
Baic resource (only use
Basic Board)
Resource 17 - 32 are
vmdb resource (only
use Basic Board)
Resource 33 - 64 are
EXIFE1 resource (only
use Expansion 1)
Resource 65 - 96 are
EXIFE2 resource (only
use Expansion 2)
Resource 97 - 128 are
EXIFE3 resource (only
use Expansion 3) (V3.5
Added)
SL1100
Program
10
2-11