Advertisement
WOLF CONVECTION STEAM OVENS
Planning Information
The convection steam oven can be installed in a standard
or flush inset application. The electrical supply for the oven
must be located in an adjacent cabinet.
Finish the edges of the opening. They may be visible when
the door is open.
For standard installations, face trim will overlap stiles and
rails. Refer to the chart below.
For flush inset installations, a minimum
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
INSTALLATION REQUIREMENTS
BASE SUPPORT
Convection Steam Oven
TRIM OVERLAP
Top
Bottom
Sides
1
/
"
reveal is
(3)
8
MIN
100 lb
(45 kg)
24" MODEL
30" MODEL
3
3
/
"
/
"
(5)
(5)
16
16
0"
0"
(0)
(0)
11
7
/
"
3
/
"
(18)
(98)
16
8
ELECTRICAL
Installation must comply with all applicable electrical codes.
Locate the electrical supply as shown in the illustrations
on the following pages. A separate circuit, servicing only
this appliance is required. A ground fault circuit interrupter
(GFCI) is not recommended and may cause interruption of
operation. Refer to the illustration below for minimum power
cord plug clearance.
Performance may be compromised if the electrical supply is
less than 240 volts.
ELECTRICAL REQUIREMENTS
Electrical Supply
Service
Receptacle
Power Cord
3"
(76)
MINIMUM CORD
CLEARANCE
Power cord clearance.
grounded, 240/208 VAC, 60 Hz
20 amp dedicated circuit
NEMA 6-20R grounding-type
6'
(1.8 m)
|
wolfappliance.com
31
Hide quick links:
Advertisement
