Wolf SO27TM/S/TH Design Manual page 104

WOLF OUTDOOR GRILLS
Planning Information
ELECTRICAL
Installation must comply with all applicable electrical codes.
The electrical outlet must be located within reach of the
power cord. A separate circuit, servicing only this appli-
ance is required. A ground fault circuit interrupter (GFCI) is
required to reduce the risk of electrical shock.
ELECTRICAL REQUIREMENTS
Electrical Supply
Service
Receptacle
Power Cord
|
104 Wolf Customer Care 800.222.7820
grounded, 120 VAC, 60 Hz
15 amp dedicated circuit
3-prong grounding-type, GFCI
6'
(1.8 m)
GAS SUPPLY
3
A gas supply line of / " rigid pipe must be provided to
(19)
4
the outdoor grill or module. If local codes permit, a certified,
1 3
3' long, / " or / "
(.9 m) (13) (19)
2 4
connector is recommended to connect the units
female inlet to the gas supply line.
If the outdoor grill is being connected to a whole house LP
supply, the LP gas pressure regulator is not provided. It
can be purchased from an authorized Wolf dealer. For local
dealer information, visit the find a showroom section of our
website, wolfappliance.com.
GAS REQUIREMENTS
NATURAL GAS
Supply Pressure
Min Line Pressure
Max Regulator Pressure
LP GAS
Supply Pressure
Min Line Pressure
Max Regulator Pressure
ID flexible metal appliance
1
/ " NPT
2
WC
5"
(12.5 mb)
7"
(17.5 mb)
14" , .5 psi
(34.9 mb) (3.5 kPa)
WC
10"
(25 mb)
11"
(27.4 mb)
14" , .5 psi
(34.9 mb) (3.5 kPa)