Reading Boot Messages - Sun Microsystems 6500 Installation Manual

FIGURE 3-7
3.3.2

Reading Boot Messages

Use the boot software messages to verify that all options are installed and
recognized by the system. After firmware completes the system self-test, a message
similar to the one below will appear on your screen. The message lists hardware
detected in the system.
Note – This screen display is an example only. The actual message displayed on the
screen will depend on the software running on your system.
8-slot Sun Enterprise 5500/4500, Keyboard Present
OpenBoot -.- FCS, --- MB memory installed, Serial #---.
Ethernet address -:-:--:-:--:--, Host ID: ------.
If firmware indicates a hardware problem at this time, refer to the
Sun Enterprise 6500/5500/4500 Systems Reference Manual, Part 3, "Troubleshooting,"
for further instructions.
Boot the system using the procedure that is appropriate for your operating system.
See the Preface, "UNIX Commands," for a reference to documentation that describes
this procedure.
3-12 Sun Enterprise 6500/5500/4500 Systems Installation Guide • August 2001
Reset Switches on the Clock+ Board
System reset
CPU reset