Enterprise 6500/5500 Cabinet Systems; Powering On The System - Sun Microsystems 6500 Installation Manual

If JumpStart completes the installation incorrectly, you may need to reinstall Solaris
2.x manually.
3.2

Enterprise 6500/5500 Cabinet Systems

3.2.1

Powering On the System

Note – It is advisable to connect an ASCII terminal to the system during
installation. See Section 2.6 "Connecting an ASCII Terminal," for terminal settings
and connections.
Observe the yellow (middle) LED on the front panel. It should go off when the boot
process completes. If it remains lit, observe the terminal screen for boot messages
produced by the firmware diagnostic program during power on.
To power on the cabinet system:
1. Begin with a safety inspection of the system:
a. Turn the system key switch to
Note – The standby position ( ) does not turn off any AC-powered drive trays in
the lower part of the system cabinet. The key switch controls only the DC power
supply and DC-powered devices in the main cabinet.
b. Turn the AC power sequencer power switch (
The AC power sequencer is at the rear of the cabinet.
c. Verify that the cabinet AC power cord is connected to a power outlet.
3-2 Sun Enterprise 6500/5500/4500 Systems Installation Guide • August 2001
(the Standby position).
FIGURE 3-2
) to Off.