Cabling The System; Preparing The System For Cabling; Removing And Replacing The Enterprise 6500/5500 Cabinet Rear Door And Kick Panel; Removing The Rear Door And Kick Panel - Sun Microsystems 6500 Installation Manual

2
C H A P T E R

Cabling the System

This chapter contains procedures for connecting the power cord to the AC power
supply and instructions for cabling the system to the network.
2.1

Preparing the System for Cabling

Make sure the server is in an area that allows access to both the front and rear of the
chassis. This site should conform to site preparation guidelines and specifications
covered in Chapter 1.
2.2 Removing and Replacing the Enterprise
6500/5500 Cabinet Rear Door and Kick
Panel
The rear door and kick panel can be removed to facilitate the installation of power
and interface cables.
2.2.1

Removing the Rear Door and Kick Panel

1. Locate the plastic key in the accessory box.
2. Open the door on the left side of the top bezel to access the key switch.
The door opens when you press on the recessed area.
2-1