Sun Microsystems 6500 Installation Manual page 45

To connect an external SCSI device to your system:
1. Connect a SCSI cable to the appropriate SCSI-2 host on the I/O+ board.
For the I/O+ board in slot 1, use an SBus card. The onboard SCSI-2 port is
reserved for the cable to the media tray.
For I/O+ boards in slots 2 through 15, use the onboard SCSI-2 port (
or an SBus card.
Onboard Single-ended SCSI Connector on the I/O+ Board
FIGURE 2-11
2. For Enterprise 6500/5500 systems only: route the cable from the I/O+ board down
along the left mounting rail inside the cabinet.
Use tie wraps to secure the cable to the left mounting rail.
3. Connect the other end of the SCSI cable to the external SCSI-2 device.
4. For Enterprise 6500/5500 systems only: replace the rear door and kick panel.
This step concludes the hardware installation for the standalone server. You can now
power on the system and test the server.
Fast/Wide SCSI-2
Chapter 2 Cabling the System
)
FIGURE 2-11
2-13