FIGURE 1-7
1.6.2
Adjusting the Levelling Pads
After moving the cabinet to its operating location, adjust the levelling pads.
1. Remove the levelling wrench from inside the server cabinet.
The levelling wrench is attached to the cabinet frame by a reusable plastic strap.
Press the plastic tab to unlock the plastic strap around the wrench, then slide part of
the strap through the lock to loosen the wrench. Do not cut the strap.
2. Fully extend the stabilizer bar (
3. Screw the two stabilizer bar levelling pads down until they are 1/8- to 1/4-inch
(three to six millimeters) above the floor.
Make sure both pads are at equal heights above the floor. This clearance allows an
extended stabilizer bar to stop the cabinet if it should begin to tilt.
1-12
Sun Enterprise 6500/5500/4500 Systems Installation Guide • August 2001
Moving the Server Safely Down the Ramps
) from the bottom of the cabinet.
FIGURE 1-9