FIGURE 3-3
3.2.2
Reading Boot Messages
Use the boot software messages to verify that all options are installed and
recognized by the system. After firmware completes the system self-test, a message
similar to the following will appear on your screen. The message lists hardware
detected in the system.
Note – This screen display is an example only. The actual message displayed on the
screen will vary with the software running on the system.
16-slot Sun Enterprise 6500, Keyboard Present
OpenBoot -.- FCS, --- MB memory installed, Serial #---.
Ethernet address -:-:--:-:--:--, Host ID: ------.
If firmware indicates a hardware problem at this time, refer to the
Sun Enterprise 6500/5500/4500 Systems Reference Manual, Part 3, "Troubleshooting,"
for further instructions.
3-6
Sun Enterprise 6500/5500/4500 Systems Installation Guide • August 2001
Reset Switches on the Clock+ Board
System reset
CPU reset