Sun Microsystems 6500 Installation Manual page 19

3. Remove inner packing materials from the top and corners of the cabinet.
4. At the front of the pallet, lift the Velcro™ strip at each end of the wooden bar to
detach the bar, then set it aside.
5. Slide out the two wooden ramps from under the cabinet.
6. Attach the wooden ramps to the pallet using the Velcro strip that is attached to
each ramp.
Ensure both wheel guides (wooden strips) are to the outside. See
Caution – Three or more people are needed to move the server cabinet safely. Two
people must push at the front of the cabinet to control the movement of the cabinet.
Caution – To prevent the cabinet from tipping over, push or pull only on the upper
half of the cabinet.
FIGURE 1-2
Chapter 1 Preparing for Installation
.
1-3