Levelling pad
(1 of 6)
Levelling Pad
FIGURE 1-8
4. Slide the stabilizer bar into the cabinet.
Caution – Always extend the stabilizer bar before pulling the disk drive trays out
for servicing.
5. Adjust the four levelling pads on the cabinet frame. The four pads should press
against the floor so that the cabinet does not move.
To adjust levelling pads on the cabinet rear, you may have to remove the kick panel.
Two captive screws attach the panel to the cabinet (
This completes the first part of the system installation.
6. If you are unable to continue the installation at this time, secure the levelling
wrench inside the cabinet and close the rear door.
).
FIGURE 1-8
Chapter 1
Preparing for Installation
1-13