Sending A Fax Using The Adf - Muratec MFX-1500E Operating Instructions Manual

Sending a fax using the
1
If the machine is already in Fax mode, skip to step 2.
If the machine is in Copy mode, press
2
Adjust the document guides — by sliding either of them to the left or right —
to fit the page(s) you'll be faxing. Your fax machine's automatic document
feeder will hold up to 50 pages of letter-sized paper, 25 pages of legal-sized
paper or 15 pages of 11 17 (ledger)-sized paper.
3
Insert the document face up. When a document is in the feeder, the
shows the current scanning width (see "
on page 3.17) and the amount of memory available:
Document Ready
A4 Mem100%
4
Adjust resolution and contrast if necessary.
Press to change the resolution.
RESOLUTION
Press to change the contrast.
CONTRAST
5
Adjust memory transmission if necessary.
Press to toggle memory transmission on and off.
MEMORY TRANSMIT
6
Enter the fax number.
Also, enter any access codes necessary, just as you would for a regular phone
call. (Example: Enter 9 to "dial out" from an office telephone system, or 1 for
long-distance.)
Press Start
919725552009_
ADF
/ to change to Fax mode.
COPY FAX
4, 4, 3" in the Glossary beginning
A B A
7
Press .
START
By pressing
machine gives this action a command number as it scans the fax document.
This command number appears on the first line of the
== Command:01 ==
You'll need to know this command number if you later wish to cancel the
transmission or to print a stored document (see pages 1.23).
8
Now, everything is up to the machines — yours and the one you're dialing.
• If the fax has been set for Quick Memory transmit, your machine scans the
first page of your document into memory, then dials the other fax. When it
makes contact, your machine transmits the stored document from memory
while at the same time scanning the remaining pages of your document
into memory. (To set Quick Memory transmission, see pages 2.31.)
• If the fax has been set for the normal memory transmit, your fax scans the
entire document into memory, then dials the other fax. When it makes con-
LCD
tact, your machine transmits the entire stored document from memory.
• If the fax is set for non-memory transmission, your machine simply dials
the other fax. When it makes contact, your machine feeds the document
through, scanning and transmitting it as it goes.
Note: The more "stuff" (called black coverage) your machine "sees" on a
page, the more slowly the page feeds through as the fax scans it. And
even if the page is relatively clean, sending it in grayscale mode or at
certain resolutions makes your machine "see" more "stuff."
The same is true if you set the contrast to Dark.
Important: If you want to cancel a transmission while scanning the docu-
9
At the end of the operation, your fax machine beeps and displays:
972-555-2009
** Complete
Important: Whenever you transmit a document, what actually appears on
Note: If the call fails, see "Redialing," page 1.22.
, you've just given your machine a command. In turn, your
START
ment, press the key.
STOP
If you want to cancel a transmission in progress, use the Review
Commands function. See "Review Commands, an introduction"
page 1.23.
**
the top line of the display depends on information stored in the
remote fax. The line may even be blank.
Getting started
for a few seconds:
LCD
1.19