Table of Contents
Advertisement
Setting CALLER ID
If the CALLER ID setting is set to ON, the caller's name and phone/fax number appear on the LCD when you
receive a call. You can also set the fax to reject unwanted calls (FAX-B840 only).
• Caller ID is only available in some countries.
• To use this feature, you will need to subscribe for a Caller ID service (only available in some countries). The Caller ID
feature uses the ETSI EN 300 778-1 protocol. Contact your local telephone company for detailed information on this
service.
1
Press [Function], then press [Start/Copy].
2
Use [
] or [
• To disable Caller ID feature, use [
[Stop] to return to standby mode.
• To enable Caller ID feature, use [
3
Press [Start/Copy].
4
Use [
] or [
Copy].
You can select from the followings:
• ANONYMOUS: The fax rejects calls from any callers who have blocked their phone/fax number from the Caller ID service.
• SELECTIVE: The fax rejects calls from specific phone/fax numbers you place in NUMBER TO REJECT list (see below).
• OUT OF AREA: The fax rejects calls from any callers in an area that does not have the Caller ID service.
• SHOW IN HISTORY?: Determine if the fax stores phone/fax number for rejected calls in memory.
5
Use [
] or [
• If you set to OFF, the setting goes on to the next CALL REJECTION setting.
• If you set SHOW IN HISTORY? to YES or NO, the setting returns to ANONYMOUS.
6
• If you set ANONYMOUS or OUT OF AREA to ON, proceed to step 11.
• If you set SELECTIVE to ON, register the specific phone/fax numbers you want to reject in
NUMBER TO REJECT list. Follow the steps below.
7
Press [Start/Copy].
8
Use [
] or [
want to register the phone/fax number, then press [Start/Copy].
9
Enter the phone/fax number using the numeric buttons, then press [Start/Copy].
10 To assign additional numbers, repeat the procedure from step 8.
To finish, press [Function], then press [Start/Copy].
11 Use [
] or [
• PLAY MESSAGE: The call will be disconnected after the ALT OUTGOING MSG (see p. 40) is played. If you set
SELECTIVE to ON in step 5, and want to select this setting, OUTGOING MESSAGE must have been recorded.
• DISCONNECT: The call will be disconnected without notice.
12 Press [Stop] to return to standby mode.
38
] to select CALLER ID, then press [Start/Copy].
] or [
] to select OFF, then press [Start/Copy]. Press
] or [
] to select ON and continue with the steps below.
] to select the type of CALL REJECTION setting you want, then press [Start/
] to select ON (YES), then press [Start/Copy].
] to select the number of NUMBER TO REJECT list (00-09) under which you
] to select PLAY MESSAGE or DISCONNECT, then press [Start/Copy].
OFF
Advertisement
Table of Contents
