Table of Contents
Advertisement
Using remote control
1
Call home.
2
The outgoing message will be played.
3
Press [#] while the outgoing message is playing. Enter your password when you hear the
beeps indicating that you should enter your password.
When your password is accepted, you will hear a confirmation tone (a short series of beeps).
4
The fax will now accept remote control commands (see List of remote control commands, p.
46).
For example, press [1][1][#] to play back any telephone messages you may have received. When playback has finished, press
[9][9][#] to end the remote control.
5
End the remote control and hang up the handset.
• A password is required to use the remote control features. However, if PIN ENTRY is set to OFF (see p. 53), it is not
necessary to enter your password when you use the FORWARDING MSG feature (see p. 47).
• If you enter an invalid password, you will hear an error tone. If you enter two invalid passwords consecutively, the
call will be disconnected.
• You should enter a remote command within 20 seconds of entering your password. If more than 20 seconds elapse
after you enter your password and you do not enter a remote command, the call will be disconnected.
• The remote control features can be used even when the fax is set to a mode other than TAM MODE.
• In FAX ONLY MODE, the outgoing message will not be played. Press [#] when the call is connected.
• In Fax/Tel mode (FAX/TEL AUTO SW), press [#] while the Fax/Tel message is playing. If you have not recorded a
Fax/Tel message, press [#] when the call is connected.
• If MAN/AUTO SWITCH is off, the fax will ring 15 times. Press [#] while the outgoing message is playing. Then,
enter your password when you hear the beeps.
7
45
Advertisement
Table of Contents
