Table of Contents
Advertisement
4
# N O Z Z L E P R I N T
# E X E C U T E
5
# N O Z Z L E P R I N T
# E X E C U T E > O K ?
6
# N O Z Z L E P R I N T
[ E X E C U T I N G
Check for missing dots and incorrect print.
7
The following pattern is printed.
- Nozzle print sample
No line is missing and
the printout is correct
YES
No line is bent and the
printout is correct
YES
Check that there are no missing or bent lines.
If missing or bent lines are found with the nozzle print, perform the normal cleaning.
If missing or bent lines remain after several normal cleanings, set [NOZZLE MAP] with the procedure below.
NO
Mark for the last nozzle (nozzle 508)
Check that nozzle print is complete
up to the right of this mark.
NO
If the spaces between
the lines are even, no line
is bent.
Press the
key.
Press the
key.
Missing lines are found
Example when lines for nozzles 224
and 344 are missing in the printout.
Bent lines are found
If there are uneven
spaces between lines,
some lines may be bent.
Example: Bent lines are found
The numbers of the nozzles for
which nozzle map has been set
are written in this area.
93
Advertisement
Table of Contents
