Table of Contents
Advertisement
Install a paper tube to the scroller.
1
Scroller
Flange stopper
When the paper tube width is the same as the media width
Con rm that the rubber spacer A is facing the correct
orientation, and crown the rubber spacer A on the
ange spacer.
(3)
(1)
Knob
(1) The ange spacer has several protrusions. Push the
ange spacer until the protrusions are completely
inserted in the paper tube.
(2) Match the ange stopper with the claw of the ange
spacer
(3) Tighten the knob to secure the ange spacer and the
ange stopper.
CAUTION
- Hold the knob to move the ange stopper. Holding
another part to move the ange stopper may lead to
injuries.
Remove the two screws and move the roll spacer to the center of
the media. There are three screwing positions.
Flange spacer
Paper tube ange
(2)
Paper tube
Roll spacer
Paper tube
Run the paper tube through the two paper tube anges so that
each paper tube ange's xing screw side would face outward.
Insert the scroller into the
paper tube, determine the
distance between the media
edge and the ange.
Attach the paper setting gauge's ange side to
the ange's spoke side.
Rotate the handle clockwise as far as it
will go, and then secure the scroller at
the point.
When the paper tube width is the same as the media width
Fix the rubber spacer C to the scroller.
Rubber spacer C
Do not move this roll
spacer.
Flange
Paper setting
gauge
Handle
57
Advertisement
Table of Contents
