Oki IP-7900-20 Basic Operation Manual page 30

To connect USB cable

USB connector
1
USB 2.0 cable (B-type connector)
2
30
IP-7900/IP-7700 Basic Operation Guide
Connect the Printer's USB 2.0 cable to the USB
connector at the rear center of the Printer.
Important!
- Use the supplied USB 2.0 cable.
- For the USB connection and the related
system, use the USB-compliant hubs and
cables supporting USB 2.0. Note that a normal
operation may not be ensured if the habs,
cables, and the other related devices are not
USB-compliant.
- Use 5m cable or shorter. If the connection
length exceeds 5m, apply hubs to extend the
connection. The hub quantity must be five
or less in total. Note that a normal operation
may not be ensured if a cable exceeding 5m is
applied, or if the cable connection exceeds 5m
without hubs.
Clamp the USB 2.0 cable to the Printer along
the wiping unit direction.
Be sure to clamp the USB cable on the Printer's wiping
unit side to:
- Protect the USB connector
- Prevent the media feed sensor's incorrect detection