Oki IP-7900-20 Basic Operation Manual page 61

4
5
Tape
Points to be noted on winding media
- If the media is not installed straight to the paper tube, a skew of media may occur.
- When the take-up direction is set as Inner take-up, the taken-up media's diameter increases and the media cannot
backfeed after printing. Select [FWD ONLY] beforehand in MEDIA BACK MODE of MEDIA REG MENU. (When the
media backfeeds in [BACK&FWD] mode, the motor idles and may cause a trouble.)
6
7
Input the data in the software RIP.
8
By pressing the
the front media edge is wound on the paper
tube.
F E E D I N G M E D I A
Install the printed media to the paper tube.
(1) Check the take-up direction, remove the slack of the
(2) Attach the media to the paper tube with adhesive
Paper tube
Set the take-up direction switch according to
Take-up direction switch
the take-up direction.
 Outer take-up
- OFF
OFF
 Inner take-up
By pressing the
wind one full turn of the media on the paper
tube.
F E E D I N G M E D I A
key, feed the media until
media, and then make sure that the media is not
deviated on the supply side and the takeup side.
tape. Tape it first at the center, and then at the right
and left sides, so that the tension is uniform across
the media width and that no wrinkles are found on
the media. The taped positions are recommended to
be totally three or more.
Inner take-up:
Media is taken up
with its print surface
coming inside.
key feed the media, and
Outer take-up:
Media is taken up
with its print surface
coming outside.
61