Table of Contents
Advertisement
Flange shaft fixture
Pass the scroller shaft through the roll spacer with fixtures
at its both sides, scroller flange, and flange shaft fixture.
Scroller flange
Flange shaft fixture
Flange spacer
Not required in LOOSE
winding mode.
Handle
34
IP-7900/IP-7700 Basic Operation Guide
Roll spacer
Scroller flange
Fixture
Scroller shaft
For outer take-up mode
For inner take-up mode
(1) Insert the ange spacer
between the scroller ange and
the media roll.
(2) Push the scroller ange until it
stops and turn the handle
clockwise until the ange is
xed to the paper tube.
NOTE:
- If you keep loosening the scroller
ange handle, it will block at a
certain level.
Unscrewing the handle beyond that
limit may damage the scroller
ange. Pay attention when
loosening the handle.
(3) Remove the ange spacer.
Move the roll spacer to the media
center, and fasten the fixtures at the
roll spacer's both sides.
The roll spacer prevents the
paper tube from bending at the
center due to the media weight.
Move it when using media that
tends to bend (100-inch media,
etc.).
Move it also if it comes in the
way of the flange spacer used
with media short in width.
Roll spacer
Roll spacer
Flange spacer
Not required in LOOSE
winding mode.
Scroller flange
(5) Cover the scroller ange's
convex part with the ange shaft
xture, and push the ange shaft
xture as far as it goes.
Flange shaft fixture
(5) Turn the knob to x the scroller
shaft.
Check the flange
spacer's correct position.
Flange spacer
The ange spacer should
be inserted to the
position indicated by the
line B.
Scroller flange
Be careful not to deform
it by applying too much
force.
Flange shaft fixture
Scroller flange
Convex part
B
A
Advertisement
Table of Contents
