Oki IP-7900-20 Basic Operation Manual page 39

17
S E L E C T M E D I A
M E D I A : P A P E R
• • •
S E L E C T M E D I A
M E D I A : B a n n e r
18
S E T R E M A I N I N G M E D I A
[ [ [ [ m
C H E C K
S L A C K E N M E D I A
Adjust the tension bar length on the supply
19
side
To print in TENSION winding mode: Conform the tension bar length with the media width.
The table below lists the tension bar combination and the tension bar's total length. Referring to the list, apply
the tension bar length nearest to the media width.
Use the tension bar with no flange 1 indicated on
To print on banner media ...
- To print on banner media, you are recommended to load the media in TENSION winding mode.
To print without winding: The table below lists the tension bar combination and the tension bar's total length.
Referring to the list, apply the tension bar length nearest to the media width.
Tension bar length
16 inches (41 cm)
S
24 inches (61 cm)
M
48 inches (123 cm)
L
16 inches (41 cm)
S
26 inches (66 cm)
ML
48 inches (123 cm)
L
Examples of tension bar combinations
Media width
16 inches (41 cm)
S
36, 38 inches
39, 44 inches
45, 52 inches
53, 60 inches
61, 68 inches
69, 76 inches
77, 82 inches
83, 94 inches
95, 104 inches
16 inches (41 cm)
S
Select [Banner] and press the
With the or keys, select a media preset for
the current media type.
Enter the remaining media length and press the
key.
When you do not know the remaining media length,
press the key without entering the length.
page 15 .
Tension bar combination
TENSION winding mode
IP-7900 IP-7700
S, S S, S
M, S ML, S
L L
M, S, S ML, S, S
L, S L, S
L, M L, ML
L, S, S –
L, M, S –
L, M, S, S –
key.
Other modes
IP-7900 IP-7700
L(light)
39