Table of Contents
Advertisement
5
C L O S E
C O V E R
O N L I N E
6
á I N K
M E D I A R E G â
ß M E D I A
R O L L ( B a n n e r )
1 6 2 5 m m
7
If the wound media diameter is so large that the media touches the media drying fan
- Move the media drying fan's position with the procedure below.
Media drying fan
Media drying fan
- Turn the media drying fan carefully so that the media drying fan connecting cable does not hung up on
the pressure control knob and surrounding sheet metals.
48
IP-7900/IP-7700 Basic Operation Guide
M . A D V à
Advance/rewind switch
Protection bar
Knob screw
Set the Printer to offline state by pressing the
key.
O N L I N E
Press the
key.
The media advance/rewind switch is activated by
selecting the media and setting the take-up reel unit's
take-up direction switch.
Wind the media by pressing the takeup-side
take-up reel switch.
(1) Remove the protection bar, and then open
the front cover.
(2) Loosen the right and left knob screws next
to the movable media drying fan.
(3) Pull the media dryer fan toward you, and
turn it upward by 90 degrees.
When the media drying fan is turned upward,
it slightly goes down and is fixed. To return the
fan to its original position, pull it up and turn
it downward by 90 degrees toward you, and
then push and secure it with the knob screws.
Advertisement
Table of Contents
