Oki IP-7900-20 Basic Operation Manual page 40

To print without winding: Use the L (light) tension bar
Use this tension bar when printing without winding, and with vinyl and solvent printing coated media.
Use the tension bar with no flange 2 indicated on
48 inches (123 cm)
L(light)
To print in LOOSE winding mode: Refer to page 56.
When the tension bar is almost same as the media width, or is slightly longer than the media width, set the
tension bar with screws to the tension bar.
Tension
bar flange
with screw
When the tension bar is clearly longer than the media width, set the tension bar flanges and fixing rings to the
tension bar.
Tension bar flange
+
Fixing ring
40
IP-7900/IP-7700 Basic Operation Guide
page 15 .
Tension bar
Tension bar flange
+
Fixing ring
Tension bar
Tension bar
flange with
screw