Backguard Installation - Thermador Pro Grand PRD364JDGC Installation Manual

Backguard Installation

When installing against a combustible surface, a High Shelf
or Low Backguard is required. A THERMADOR High Shelf
or Low Backguard must be purchased separately. See
"Installation Clearances" on page 5.
When using the Flush Island Trim, THERMADOR
recommends a minimum 12" (305 mm) rear clearance to a
combustible surface (see Figure 1, Cabinet Clearances).
Clearances from non-combustible materials are not part of
the ANSI Z21.1 scope and are not certified by
CSA. Clearances of less than 12" (305 mm) must be
approved by the local codes and/or by the local authority
having jurisdiction.
NOTE:
If a Backsplash is to be used in addition to a backguard,
install the Backsplash first and the backguard second
before sliding range into place.
HIGH SHELF PARTS INCLUDED
High Shelf top panel
High Shelf front panel
T-20 Torx stainless screws
T-20 Torx drill point screws
Installation Guide
LOW BACK PARTS INCLUDED
Low Back panel
T-20 Torx stainless screws
T-20 Torx drill point screws
Installation Guide
TOOLS NEEDED
T-20 Torx head screwdriver or drill
Protective Work Gloves
English 22
WARNING!
Fingers or hands could get pinched when installing the
backguard. Severe injury could result. Use extreme
caution and wear thick protective gloves to avoid
potential laceration to finger or hand while sliding the
backguard down onto the range.
CAUTION!
The High Shelf can get very hot! DO NOT place the
following items on top of the High Shelf:
• plastics or containers that can melt
• flammable items
• a total load over 30 pounds (13.6kg)
Figure 25: High Shelf & Low Back Front View