Step 8: Backguard Installation (Optional) - Thermador PROFESSIONAL PRO GRAND PRD364WLGU Installation Instructions Manual

3. Remove upper nuts only from the terminal block studs.
Do not remove nuts which secure range internal wiring
leads.
4. Secure the neutral, grounded wire of the supply circuit,
to the center stud (silver colored) of the terminal block
(see Figure 20).
5. Secure the L1 (red) and L2 (black) power leads to the
outside corresponding terminal block studs (brass
colored).
6. Secure one end of the mounted looped neutral wire,
located beneath terminal block, to the center stud of
the terminal block with nut and keep the other end of
the wire screwed into the back of the range.
7. Tighten nuts securely.
Red/L1
Wire
Ground link
provided on range
8. Reinstall the Terminal Block Cover.
INSTALLER — show the owner the location of the circuit
breaker. Mark it for easy reference.
STEP 8: Backguard
Installation (optional)
MODEL LOW BACK
36'' PA36JLBG
48'' PA48JLBG
48'' Steam PA48JLBSG
Table 3: Backguard Kit Model Numbers
WARNING
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
Installation Instructions
Black/L2
Wire
White/
Neutral Wire
Figure 20: 3-Wire Connection
FLUSH ISLAND TRIM
Included with range
Included with range
Included with range
WARNING
Fingers or hands could get pinched when installing the
backguard. Severe injury could result. Use extreme
caution and wear thick protective gloves to avoid
potential laceration to finger or hand while sliding the
backguard down onto the range.
Installation methods will vary upon need. Before you begin
read these instructions carefully. Observe all local codes
and ordinances.
Backsplash Installation (PA[36, 48]JBS)
PARTS INCLUDED
10 – 1" (25.4 mm)
screws
1 – Backsplash
The Backsplash must be installed prior to installing an
overhead hood given that the hood shell covers the top
mounting screws of the Backsplash.
To protect against scratches, leave protective film on
Backsplash until after installation is complete.
If range is already installed, refer to the manufacturer's
instructions to disconnect gas and power supplies. Move
range forward to gain access to rear of unit.
1. Locate and lightly mark wall studs. Wall studs are
usually installed with a 16'' or 24'' (406 or
1372 mm) space on center.
2. The height of the hood will determine the height of the
top edge of the Backsplash. The Backsplash should be
mounted so that the bottom rear edge of the hood
overlaps the Backsplash 1
3. Per each wall stud, use (2) 1'' (25.4 mm) Phillips head
screws to secure both the top and bottom of the
Backsplash (see Figure 21). Space screws evenly
across top and bottom of Backsplash.
• Due to variable wall stud widths and varying
Backsplash widths, in some cases only one wall
stud may be found at the mounting location.
TOOLS NEEDED
Phillips screwdriver or
drill
Tape measure
'' (38 mm).
½
English 20