Thermador Pro Grand PRD364JDGC Installation Manual page 29

Griddle Tilt Adjustment (not all models)
If the range is equipped with an electric griddle, check the
griddle frame adjustment by pouring two tablespoons of
water on the back of the griddle plate. The water should
slowly roll into the grease tray. If not, adjust the two screws
under the back of the frame. Start with one half turn
counterclockwise (CCW) of the screws. Further adjustment
should be made by one-quarter turn until water slowly flows
into the grease tray.
Figure 32: Griddle Leveling Screws
WARNING!
To avoid risk of injury, never operate griddle without the
griddle plate installed. Never use griddle in a manner
that is not prescribed by the Use and Care Manual.
The griddle plate must always be in place when the
griddle is turned on.
Assembling the Grill (not all models)
Refer to "Using the Electric Grill" in the Use and Care
Guide.
English 26
Installing the Leg Covers
1. Remove plastic coverings from the stainless steel
2. Place the smaller cover, with cutouts facing up, inside
Move griddle Move griddle Move griddle
plate to the side plate to the side plate to the side
and turn leveling and turn leveling and turn leveling
screws screws screws
3. Beneath the range, wrap the cover assembly around
4. Slide the outer cover up while the inner piece remains
covers.
the larger cover with the openings of both stacked and
facing the back.
the leg.
on the floor. The mating part has dimples for which the
holes of the larger cover should seize. You should feel
a definitive click, letting you know that the cover
assembly has been mounted to the unit.
Figure 33: Leg Covers
Figure 34: Range Dimples