Thermador Pro Grand PRD364JDGC Installation Manual page 30

5. Secure the cover assembly through the dimpled holes
with (2) ½" stainless steel Torx head screws (included),
as shown below.
Figure 35: Leg Cover Mounting Holes
6. Repeat for all visible legs.
• If additional leg covers are required, they may be
ordered from the service center by calling
1-800-735-4328 at no charge for up to one year
after purchase date of the appliance. When
ordering, refer to Leg Cover Kit part no. 00751305.
Toe Kick Panel (optional)
TOE KICK PARTS INCLUDED
1 – Toe Kick Panel
4 – T-20 Torx drill point screws
1 – Installation Guide
TOOLS NEEDED
T-20 Torx head screwdriver or drill
Protective work gloves
1. Remove the screws securing the leg covers (see
Figure 35: "Leg Cover Mounting Holes"). Dismount the
leg covers from the extruded dimples.
2. Remove protective plastic covering from the Toe Kick
Panel.
3. Beneath the range, with the holes and flange facing up,
wrap the Toe Kick Panel around the cast aluminum
base.
(PA [36,48] JTKG)
4. The mating part has extruded dimples on both sides for
which the holes of the Toe Kick Panel should seize.
You should feel a definitive click, letting you know that
the part has been installed.
5. Mount the Toe Kick Panel on both sides of the unit into
the extruded dimples using the (4) T-20 Torx drill point
screws provided.
Figure 36: Toe Kick Panel Installation
Data Rating Label
The data rating label shows the model and serial number of
the range. It is located in the gap created by the right side
of the oven cavity and the range side panel (Figure 37).
The electric wiring diagrams and schematics are attached
behind the door trim, and should not be removed except by
a service technician, then replaced after service
(Figure 37).
Data Rating
Label Location
Figure 37: Rating Label Location
English 27