Step 7: Backguard Installation (Optional); Backsplash Installation - Thermador PROFESSIONAL PRO HARMONY PRD364GDHC Installation Manual

Hide thumbs Also See for PROFESSIONAL PRO HARMONY PRD364GDHC:
Table of Contents

Advertisement

Available languages

Available languages

Step 7: Backguard Installation (optional)
6"Std
....
,
Mode
LowBack
.!gh She f I
30"
PA30GLBH
N/A
PA30GHSH
36"
N/A
PA36GLBH
PA36GHSH
48"
N/A
PA48GLBH
PA48GHSH
Included with range
Included with range
Included with range
Table 4: Baekguard Kit Model Numbers
Installation methods will vary upon need. Before you begin
read these instructions carefully. Observe all local codes
and ordinances.
Backsplash
Installation
(PA [30, 36, 48] JBS)
PaNs Included
Tools Needed
_
10- 1" (25.4 mm)
screws
Phillips screwdriver or
drill
1 - Backsplash
Tape measure
1 - Installation Guide
Pencil
The Backsplash must be installed prior to installing an
overhead hood given that the hood shell covers the top
mounting screws of the Backsplash.
To protect against scratches, leave protective film on
Backsplash until after installation is complete.
If range is already installed, refer to the manufacturer's
instructions to disconnect gas and power supplies. Move
range forward to gain access to rear of unit.
, WARNING:
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
1.
Locate and lightly mark wall studs. Wall studs are
usually installed with a 16" or 24" (406 or 610 mm)
space on center.
2.
The height of the hood will determine the height of the
top edge of the Backsplash. The Backsplash should be
mounted so that the bottom rear edge of the hood
overlaps the Backsplash 1½" (38 mm).
3.
Per each wall stud, use (2) 1" (25.4 mm) Phillips head
screws to secure both the top and bottom of the
Backsplash (see Figure 15). Space screws evenly
across top and bottom of Backsplash.
Due to variable wall stud widths and varying
Backsplash widths, in some cases only one wall
stud may be found at the mounting location.
4.
Remove protective plastic.
,..,=..,
E
E
P_
kO
O
o
30':36':48"
(762,914,1219
mm)--_
Figure 15: Backsplash
Installation
English 18

Advertisement

Table of Contents
loading

Table of Contents