Step 7: Backguard Installation - Thermador Professional Series Installation Instructions Manual

Step 7: Backguard installation
The backguard must be attached before sliding the
range into the final installed position. A Low Back or
High Shelf backguard must be installed when there is
less than a 12" clearance between combustibles and
the back of the range above the cooking surface. (See
Fig. 2A and 2B on Page 7).
An Island Trim is available for covering the backguard
mounting flanges for island installations, where there
is a minimum of 12" of horizontal clearance between
combustibles and the back of the range. (See Fig. 2B
on Page 7).
The backguard is inserted, as shown in Fig. 14, into
the guide channels on the back of the range. Secure
the backguard with the (4) sheet metal screws pro-
vided.
Front of Unit
I
L
Chart C: BACKGUARD KIT MODEL NUMBERS
RANGE MODEL NO, 9" STD. LOW HACK 12" LOW HACK 22" HIGH SHELF
PD304 Included with Range NiA HS30R
PD36 NiA LB36R HS36R
PD48 N!A LB48R HS48R
Backguard
Installed
3°3/4" ISLAND TRIM
IT30R
IT36R
IT48R
17