Backguard Installation - Thermador Pro Harmony Series Installation Instructions Manual

6. Secure the neutral, grounded wire of the supply
circuit, to the center stud (silver colored) of the
terminal block.
7. Secure the L1 (red) and L2 (black) power leads to the
outside corresponding terminal block studs (brass
colored).
8. Remove the green ground screw and serrated washer
located beneath the terminal block. Screw one end of
the included white jumper wire to the chassis beneath
the terminal block with the green ground screw.
Secure the other end of the wire to the center stud of
the terminal block with nut.
a
a – Red/L1
c – White/neutral
9. Tighten nuts securely.
10. Reinstall the Terminal Block Cover.
Page. 19
d
c
b
b – Ground link wire provided
in small bag.
d – Black/L2

Backguard installation

9 WARNING
Fingers or hands could get pinched when installing
the backguard. Severe injury could result. Use
extreme caution and wear thick protective gloves to
avoid potential laceration to finger or hand while
sliding the backguard down onto the range.
9 WARNING
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
Installation methods will vary upon need. Before you
begin read these instructions carefully. Observe all local
codes and ordinances.
To install the low backguard
1. Remove the T-20 torx screws in the front face of the
included island trim.
2. Remove the T-20 torx screws securing the trim to the
side panels, and the T-20 torx screws securing the
piece to the back panel. Lift up to fully remove.