Step 8: Backguard Installation (Optional) - Thermador PROFESSIONAL PRO GRAND Installation Instructions Manual

IMPORTANT:
For all gas ranges with electric griddle, dedicated 20 AMP
service is required for proper operation. Before you plug in
an electrical cord, be sure all controls are in the OFF
position.
For appliances equipped with a cord and plug, do not cut or
remove the ground prong. It must be plugged into a
matching grounding type receptacle to avoid electrical
shock. If there is any doubt as to whether the wall
receptacle is properly grounded, the customer should have
it checked by a qualified electrician.
INSTALLER — show the owner the location of the circuit
breaker. Mark it for easy reference.
STEP 8: Backguard
Installation (optional)
MODEL LOW BACK
36'' PA36JLBG
48'' PA48JLBG
Table 3: Backguard Kit Model Numbers
WARNING
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
WARNING
Fingers or hands could get pinched when installing the
backguard. Severe injury could result. Use extreme
caution and wear thick protective gloves to avoid
potential laceration to finger or hand while sliding the
backguard down onto the range.
Installation methods will vary upon need. Before you begin
read these instructions carefully. Observe all local codes
and ordinances.
Backsplash Installation (PA[36,48]JBS)
PARTS INCLUDED
10 – 1'' (25.4 mm)
screws
1 – Backsplash
Installation Instructions
FLUSH ISLAND TRIM
Included with range
Included with range
TOOLS NEEDED
Phillips screwdriver or
drill
Tape measure
The Backsplash must be installed prior to installing an
overhead hood given that the hood shell covers the top
mounting screws of the Backsplash.
To protect against scratches, leave protective film on
Backsplash until after installation is complete.
If range is already installed, refer to the manufacturer's
instructions to disconnect gas and power supplies. Move
range forward to gain access to rear of unit.
1. Locate and lightly mark wall studs. Wall studs are
usually installed with a 16'' or 24'' (406 or
1372 mm) space on center.
2. The height of the hood will determine the height of the
top edge of the Backsplash. The Backsplash should be
mounted so that the bottom rear edge of the hood
overlaps the Backsplash 1
3. Per each wall stud, use (2) 1'' (25.4 mm) Phillips head
screws to secure both the top and bottom of the
Backsplash (see Figure 15). Space screws evenly
across top and bottom of Backsplash.
• Due to variable wall stud widths and varying
Backsplash widths, in some cases only one wall
stud may be found at the mounting location.
4. Remove protective plastic.
Installing a Backsplash with a Keep Hot
Shelf
A hood can be installed first if the Backsplash is to be
installed with a Keep Hot Shelf given that the Keep Hot
Shelf covers the top mounting screws of the Backsplash.
To protect against scratches, leave protective film on the
Backsplash until after installation is complete.
'' (38 mm).
½
Figure 15: Backsplash Installation
English 18