Step 5: Installing Anti-Tip Device - Thermador Pro Grand PRD364JDGC Installation Manual

4. If door or handle appears slightly tilted, you may adjust
the hinge receiver by rotating the large Torx-head
screw located directly above the hinge receiver with a
T-20 Torx driver. Rotate each screw respective to its
side and direction the door needs to be adjusted
(Figure 11).
Figure 11: Hinge Receiver Adjustment Screw
NOTE:
The steam oven door is not adjustable.
Adjustment for the Warming Drawer Front
1. To align the warming drawer to the steam oven door,
loosen the (2) Torx screws on both sides of the drawer
frame to adjust the tilt. Tighten the screws.
2. To align the gap between the doors, loosen the (4)
Torx screws on the back side of the warming drawer
door. Adjust the vertical and horizontal direction until
the oven door edges are aligned. Tighten the screws.
2
Figure 12: Warming Drawer Adjustment
English 12
1
Step 5: Installing Anti-Tip
Device
For all ranges, an anti-tip device must be installed as per
these instructions.
WARNING!
RANGE TIPPING HAZARD:
— All ranges can tip and injury can result.
To prevent accidental tipping of the
range, attach it to the floor by installing
the Anti-Tip Device supplied.
— A risk of tip-over may exist if the
appliance is not installed in accordance
with these instructions. For all ranges an
anti-tip device must be installed.
— A child or adult can tip the range and be
killed.
— Do not operate the range without the anti-
tip device in place and engaged. Failure
to do so can result in death or serious
burns to children or adults.
If the range is pulled away from the wall for cleaning,
service or for any other reason, ensure that the Anti-Tip
Device is properly re-engaged when the range is into
position. In the event of abnormal usage (such as a
person standing, sitting, or leaning on an open door),
failure to take this precaution can result in tipping of the
range. Personal injury might result from spilled hot
liquids or from the range itself.
ATTENTION — PROPERTY DAMAGE:
• Contact a qualified installer or contractor to determine
the proper method for drilling holes through the wall or
floor material (such as ceramic tile, hardwood, etc.)
• Do not slide the range across an unprotected floor.
• Failure to follow these instructions may result in
damage to wall or floor coverings.
THERMADOR
QTY
SERVICE NO.
00415078 4
00655322 1
DESCRIPTION
Screw, Phillips, #10 x 1½"
Anti-Tip Bracket